Dec 10
18

Building a P-40 WarHawk Chapter III

2 Comments


www.nitroplanes.com This fierce P-40 Warhawk comes with quality hardware including the spinner. Decals are ready applied and protected by clear coat. The model is thus very durable and easy to build. The kit comes with fixed landing gear and optional twist and turn retracts fitting. The fuselage is a huge fiberglass moulding with enough room to fit the engine and etc.

Tags: , ,

This entry was posted on December 18, 2010 at 10:57 am. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

Posted in decals by admin 2 Comments

2 Responses to "Building a P-40 WarHawk Chapter III"

  • rcflyerct says:
    December 18, 2010 at 11:35 am

    @yittymitty11 : Typically, that happens only when the plane comes to an abrupt stop and a quick way to check is to hold the nose up while running, if the engine stops, the clunk could be forward, I personally haven’t had any problems with the fuel tank setup as I use this method and its been worry free.

  • yittymitty11 says:
    December 18, 2010 at 11:48 am

    can i give you a tip about the fuel line going to the carby put a piece of aluminum tubing between the clunk and the tubing it will stop the clunk folding forwards and getting stuck

Leave a Comment